Electronic Fluxmeter EF 14
Danger!
Do Not Operate In An Explosive Atmosphere
Do not operate the instrument in the presence of flammable gases or fumes.
Operation of any electrical instrument in such an environment constitutes a
definite safety hazard.
Caution!
Keep Away From Live Circuits
Operating personnel must not remove instrument covers. Component
replacement and internal adjustments must be made by qualified
maintenance personnel. Do not replace components with power cable
connected. To avoid injuries, always disconnect power and discharge
circuits before touching them.
Caution!
Do Not Substitute Parts Or Modify Instrument
Due to the risk of electrostatic discharge and because of the danger of
introducing additional hazards, do not install substitute parts or perform any
unauthorized modification to the instrument. Return the instrument to
MAGNET-PHYSIK Dr. Steingroever GmbH, Cologne, Germany or an
authorized representative for service and repair to ensure that safety features
are maintained.
1.1.3 Authorized Operator
The EF 14 may only be used and connected by personnel authorized by owner.
The owner must in this case:
place operating instructions at the operator's disposal at all times and
make sure the operator has read and understood them.
1.1.4 Place of Installation
No special safety measures are necessary at the place of installation.
Important!
The EF 14 must always be placed on a solid base, e.g. a table.
Never operate the equipment in places where one or more of the limiting
he ambient conditions are exceeded.
To Next Page
Loading...
