8 Appendix
80 MAGNETEK HPV1000 AC Elevator Drive Technical Manual
WARNING! Electrical Shock Hazard. The motor must be at a complete stop before performing any maintenance, inspection, or wiring.
• With a PM motor, drive output must be fully interrupted when the power is shut off and the motor is still
rotating.
Failure to comply can result in personal injury from electrical shock.
Drive Label Warnings
Always heed the warning information listed in Figure 16 in the position shown in Figure 17.
Figure 13
Figure 16 Warning Information
Figure 14
Figure 17 Warning Information Position
WARNING
Read manual before installing.
Wait 5 minutes for capacitor
discharge after disconnecting
power supply.
To conform to requirements,
make sure to ground the supply
neutral for 400V class.
After opening the manual switch
between the drive and motor,
please wait 5 minutes before
inspecting, performing
maintenance or wiring the drive.
Risk of electric shock.
Hot surfaces
Top and Side surfaces may
become hot. Do not touch.
●
●
●
●
●
To Next Page
Loading...