Engineered XLTX Transmitter Instruction Manual
December 2016
Page 28 of 49
The transmitter’s display will show:
> RCP IR Cfg
Ready...
Press start to exit
At this point, the transmitter is ready to send and receive commands from RCP. When finished
press the OFF-ON START toggle to exit back to the menu.
NOTE: See RCP User’s Guide for detailed instruction on reading and writing the configuration.
4.2.2.10 Exit Without Save
If the user does not wish to save any of the configuration changes made, the Exit Without Save
option can be selected.
NOTE: None of the changes will be saved upon selection of this option. The transmitter will start
up with the last saved configuration settings.
4.2.2.11 Exit With Save
Selection of this option saves all changes and exits the Setup Mode.
Upon exit, the device will start up with the new configuration settings.
To Next Page
Loading...
