Magnetrol Eclipse 706 - Page 22

22
BE57-646 ECLIPSE Guided Wave Radar Transmitter - FOUNDATION fieldbus
™
BKCAL_IN: The analog input value and status for another
blocks BKCAL_OUT output.
BKCAL_HYS: The amount the output must change away
from its output limit before the limit status is turned off,
expressed as a percent of the span of the output.
BKCAL_OUT: The value and status required by the
BKCAL_IN input for another block.
BLOCK_ALM: Used for all configuration, hardware, or
system problems in the block.
BLOCK_ERR: Reflects the error status associated with the
hardware or software components associated with a block.
BYPASS: Used to override the calculation of the block.
CAS_IN: The remote setpoint value from another block.
CONTROL_OPTS: Allows one to specify control strategy
options.
DV_HI_ALM: The DV HI alarm data.
DV_HI_LIM: The setting for the alarm limit used to
detect the deviation high alarm condition.
DV_HI_PRI: The priority of the deviation high alarm.
DV_LO_ALM: The DV LO alarm data.
DV_LO_LIM: The setting for the alarm limit used to
detect the deviation low alarm condition.
DV_LO_PRI: The priority of the deviation low alarm.
FF_GAIN: The feedforward gain value.
FF_SCALE: The high and low scale values associated with
FF_VAL.
FF_VAL: The feedforward control input value and status.
GAIN: The proportional gain value. This value cannot
equal zero.
GRANT_DENY: Options for controlling access of host
computers to alarm parameters of the block.
HI_ALM: The HI alarm data.
HI_HI_ALM: The HI-HI alarm data.
HI_HI_LIM: The setting for the alarm limit used to detect
the HI HI alarm condition.
HI_HI_PRI: The priority of the HI-HI Alarm.
HI_LIM: The setting for the alarm limit used to detect the
HI alarm condition.
HI_PRI: The priority of the HI alarm.