Magnetrol Eclipse 706 - Page 23

23
BE57-646 ECLIPSE Guided Wave Radar Transmitter - FOUNDATION fieldbus
™
IN: The connection for the PV input from another block.
LO_ALM: The LO alarm data.
LO_LIM: The setting for the alarm limit used to detect the
LO alarm condition.
LO_LO_ALM: The LO _LO alarm data.
LO_LO_LIM: The setting for the alarm limit used to
detect the LO_LO alarm condition.
LO_LO_PRI: The priority of the LO_LO alarm.
LO_PRI: The priority of the LO alarm.
MODE_BLK: The actual, target, permitted, and normal
modes of the block.
OUT: The block input value and status.
OUT_HI_LIM: The maximum output value allowed.
OUT_LO_LIM: The minimum output value allowed.
OUT_SCALE: The high and low scale values associated
with OUT.
PV: The process variable use in block execution.
PV_FTIME: The time constant of the first order PV filter.
PV_SCALE: The high and low scale values associated with
PV.
RATE: The derivative action time constant.
RCAS_IN: Target setpoint and status that is provided by a
supervisory host.
RCAS_OUT: Block setpoint and status that is provided to
a supervisory host.
RESET: The integral action time constant.
ROUT_IN: Block output that is provided by a supervisory
host.
ROUT_OUT: Block output that is provided to a superviso-
ry host.
SHED_OPT: Defines action to be taken on remote control
device timeout.
SP: The target block setpoint value.
SP_HI_LIM: The highest SP value allowed.
SP_LO_LIM: The lowest SP value allowed.
SP_RATE_DN: Ramp rate for downward SP changes.
SP_RATE_UP: Ramp rate for upward SP changes.