8-52
© Copyright Mahindra & Mahindra Ltd.012016
It works on the closed loop system principle to maintain the set
speed of the vehicle; the system controls the fuel injection of the
engine in order to maintain the set speed.
Cruise control enhances your comfort while driving and allows you
to effortlessly maintain the desired lane speed limit. Improper use of
the cruise control can lead to an accident.
A VMS C RES
B
SET + / —
D CRUISE OFF
Cruise control will function only under the following conditions;
• The vehicle is cruising above 40 kmph
• Engine RPM above 1200 RPM
• Vehicle is in any gear except 1st or reverse
• Clutch pedal released
• Brake pedal released
• Cruise is activated first time in an ignition cycle by SET+ / SET-
button
• Subsequent cruise engagements can be done by RESUME SET+
/SET- buttons in the same ignition cycle
Cruise control is deactivated under the following conditions;
• CRUISE button is pulled
• Brake or clutch pedal depressed
• If the vehicle speed exceeds the cruise set speed by 30 kmph by
accelerator pedal intervention
• If the vehicle speed is increased by 10 kmph for more than 30
sec. by pressing the accelerator pedal
• When Set+/Set- switch is pressed for more than 12 sec. (In this
case the vehicle will not go into cruise mode in that ignition cycle.
In order to restore the cruise function, switch OFF the ignition,
wait for 30 sec. and switch ON the ignition)
• Cruise influencing error indicated by check engine lamp, OBD
lamp, etc.
Cruise Control Activation
Drive the vehicle to the desired cruising speed (any value greater
than 20 kmph), press and hold the SET + button until the cruise
lamp in the instrument cluster illuminates. If cruise is deactivated
(eg. by depressing brake to handle an intervention in the road etc.),
FEATURES AND CONTROL
To Next Page
Loading...
Need help?
General
