35
5.2.3. During initial setup, and as required; apply a
small amount of grease to each tower in areas of tower
bottom receiver (A), tower top receiver (B), and handle
pin bushing (C). This will aid in parking loader.
Tower
5.2.4. Before servicing your tractor, always do one of the following.
. Park the loader off of the tractor. B. Position loader with bucket and/or attachment
level with ground, then relieve all hydraulic
pressure.
CAUTION: Do not stand, walk, or work under a raised loader or attachment unless it is securely
blocked or held in position. Accidental movement of valve handle/handles or leaks in the
hydraulic system could cause the loader to drop, or attachment to dump, causing severe injury.
5.2.5. Clean area identified with arrow of all
material if build up occurs during operation. This
will prevent damage to loader components.
NOTE:
Clean this
area of all
material if
build up
occurs
during
operation.
To Next Page
Loading...
Need help?
General