61
17.3. SKID STEER TOOL CARRIER SYSTEM SERVICE & LUBRICATION
IMPORTANT: To maintain
your Skid Steer Tool
Carrier System functioning
properly, always keep
handle components and
latching areas clean.
Keep all these areas clean.
Refer to 3 photos
at right and below.
IMPORTANT: To maintain
your Skid Steer Quick
Attach System functioning
properly, always inspect
Skid Steer Quick Attach
System components for
damage or wear. If damage
or wear exists, replace
components immediately.
17.3.1. Check and tighten
this 1/2" bolt after every 20
hours of operation.
17.3.2. A small amount of
light oil applied to pins
occasionally will improve
ease of function of skid steer
latching components.
17.3.3. Inspect latching
components and groove
pins. If damaged, only
replace with Factory
approved components.
To Next Page
Loading...
Need help?
General