Mahindra ML170 series - Skid Steer Tool Carrier Handles in Engaged Position

63
18.3. SKID STEER TOOL CARRIER HANDLES IN ENGAGED POSITION
18.3.1. To position handles into the
handle engaged position, push skid
steer tool carrier handle downward
until they latch into position.
Push Handles
Downward.
NOTE: Handles should be positioned parallel to ground if
properly latched.
IMPORTANT: If properly latched into skid steer tool carrier
attachment, the lower skid steer groove pin should be contacting
quick attach pin support bar.
(2) Handles engaged position.
(3) Groove pin.
(4) Contact point.
(5) Pin support bar.