64
19. INSTALLING BUCKET OR ATTACHMENT
TO SKID STEER TOOL CARRIER
IMPORTANT: Refer to Pages 62 to 63 for instructions concerning Skid Steer Tool Carrier Handles
Disengaged and Engaged Positions.
CAUTION: Before leaving the tractor seat, stop the engine and lock brakes when installing or
removing bucket or attachment.
CAUTION: Do not stand, walk, or work under a raised loader or attachment unless it is securely
blocked or held in position. Accidental movement of valve handle/handles or leaks in the
hydraulic system could cause the loader to drop, or attachment to dump, causing severe injury.
19.1. OPERATING INSTRUCTIONS
19.1.1. To attach bucket or attachment to loader,
lower loader boom to ground with Skid Steer Tool
Carrier attachment rolled forward slightly.
19.1.2. To position handles into the
handle disengaged position, pull
skid steer tool carrier handle
upward.
Pull Handles
Upward
(1) Handles disengaged position.
19.1.3. Roll Skid Steer Tool Carrier attachment
forward by extending tilt cylinders just enough to
allow Skid Steer Tool Carrier upper vee to engage
Skid Steer attachment vee channel. Drive tractor
forward, aligning Skid Steer Tool Carrier vee
components.
Align Skid Steer Tool Carrier vee
with Skid Steer Attachment vee channel.
NOTE: Over extension of tilt cylinders during this
operation could cause damage to Skid Steer Tool
Carrier handles due to handles contacting bucket
or attachment.
To Next Page
Loading...
Need help?
General