Mamiya 645DF - TYPES OF CUSTOM FUNCTIONS; C-00 to C-09 Custom Function Details

Chapter 1 - Basic info
185
Chapter 13 - Custom functions
types of custom functions
C-00 Custom functions profile [SEL]
0: None (default=0)
1: A
2: B
3: C
When “0” has been selected and set, none of
the custom items can be set.
C-01 EV-Steps [StEP]
This function is used to set the size of
increments concerning the shutter speed,
f-number and exposure compensation value.
0: 0.3 (1/3EV step: default setting)
1: 0.5 (1/2EV step)
2: 1.0 (1EV step)
C-02 Lens change [IrIS]
This function is used to set the f-number display
method for the previously used lens when the
lenses have been interchanged. The default
setting is “0” in which case the f-number of the
lens prior to the changeover is displayed.
0: Previous f-number
1: Aperture open
2: Minimum aperture setting
C-03 Sleeptimer [HOLd]
This function is used to set the time for sleep
mode to be established after the camera’s
power is turned on. The default setting is 15
seconds.
0: 15 seconds
1: 30 seconds
2: 60 seconds
3: Disabled
The batteries will continuously lose power when
“On” (no sleep mode) has been set.
C-04 Battery Type [batt]
This function is used to set the batteries used
in the camera so that the remaining battery
charge will be displayed correctly on the
external LCD panel.
0: Alkaline
1: Ni-CD, Ni-MH
2: Li-ION
(ONLY FOR USE WITH VERTICAL GRIP)
C-05 Bracketing [Stno]
Setting bracket’s width for auto bracketing
setting
0: 3 Exposures
1: 5 Exposures
2: 7 Exposures
C-06 Front/Rear dial [dF]
This function is used to interchange the
functions of the front and rear dials in the M
(manual mode).
0: Front dial: TV, rear dial: Av [OF]
1: Front dial: AV rear dial: Tv [On]
C-07 Rear dial in P mode [d_AC]
Initializing the P mode on the rear dial then
changing the function to the front dial will
cancel out P mode function on the rear dial.
0: Enable
1: Disable
C-08 Dial Direction [d_dl]
This function is used to determine the direction
in which the electronic dial is to be rotated
to increase and decrease shutter speed, the
f-number, and exposure compensation.
0: CW: Decrease [OF]
1: CW: Increase [On]
C-09 AEL & AFL button [AEFL]
This function is used to set whether to
interchange the operations of the front and rear
AEL and AFL buttons.
0: Default setting
(front: AFL, rear: AEL) [OF]
1: Switched (front AEL, rear: AFL) [On]