Mamiya RB67 - Photographing; Basic Photographing Procedure; Unloading Film

• Photographing
22
1. Attach the loaded holder to the camera
and pull out the dark slide ~ R 1).
2. Adjust the focus , determine the ex-
posure setting, and release the shutter.
(The
shutter release button cannot be
pressed unless the dark slide is removed .)
3. When the shutter is released , the
double-exposure warning signal (R5) turns
red
Move the film wind-stop release lever
(R 9 ) in the direction of the arrow , wind the
film advance lever until it stops , and prepare
for the next photograph. As soon as the
release lever (R 9) is moved , the warning
signal turns white.
NOTE : 00 not remove your finger from the
shutter coc king lever until you have com-
pleted the full winding action.
If you move the shutter cocking lever a
trifle and then remove your finger from the
lever , the warning signal will turn red even
if no picture has been taken.
Multiple Exposure Photography
By cocking the shutter and repeating
exposures without advancing the film (even
though the warning signal is red), fascinating
multiple exposures can be created.
Dark Slide Storing Method
By inserting it fromabove, the dark slide
can be stored on the side of the camera
body.
Unloading Film
1. When you finish exposing the full
number of exposures, the film advance
lever will be freed . Then wind the film com-
pletely to the end of the leader paper.
2. Open the back cover of the holder and
remove the film insert. Press the spool re-
lease pin (R 13), remove the full spool, then
wrap and seal the film to protect it from
loosening.
3. Move the empty spool to the take-up
side. The insert is ready for reloading.
The exposure counter (R 4) automatically
resets to S (start) as soon as the back cover
is opened. When the exposure counter
shows other than S, a film is loaded in the ,
holder .