Manitou TMT 25 I K ST5 S1 User Manual

1 - 6
INSTRUCTIONS TO THE COMPANY MANAGER
THE SITE
- Proper management of the machine's area of travel will reduce the risk of accidents:
• Ground not unnecessarily uneven or obstructed,
• No excessive slopes,
• Pedestrian traffic controlled, etc.
THE OPERATOR
- Only qualified, authorized personnel can use the machine. This authorization is given in writing by the appropriate person
in the establishment where the machine is to be used and must be carried permanently by the operator.

IMPORTANT

Experience has shown that there are a number of inappropriate ways in which the machine might be used.
Such foreseeable misuse, of which the main examples are listed below, is strictly forbidden:
- The foreseeable abnormal behavior resulting from ordinary negligence, but not from any intentional misuse of the equipment.
- The reflex reactions of a person in the event of a malfunction, incident, fault, etc. during operation of the machine.
- Behavior resulting from application of the "principle of least effort" when performing a task.
- For certain machines, the foreseeable behavior of such persons as: apprentices, teenagers, handicapped persons, trainees tempted to drive a machine, operators
tempted to operate a machine to win a bet, in competition or for their own personal experience.
The person in charge of the equipment must take these criteria into account when assessing whether or not a person will make a suitable driver.
THE MACHINE
A - SUITABILITY OF THE MACHINE FOR THE TASK
- MANITOU has ensured that this machine is suitable for use under the standard operating conditions defined in this
operator's manual, with a STATIC TEST COEFFICIENT OF 1.33 and a DYNAMIC TEST COEFFICIENT OF 1, as specified in
harmonized standard EN 1459 for variable reach machines.
- Before commissioning, the company manager must make sure that the machine is appropriate for the work to be done,
and perform certain tests (in accordance with current legislation).
B - ADAPTING THE MACHINE TO USUAL ENVIRONMENTAL CONDITIONS
- Our machines are designed to be used within a temperature range of -18°C to +43°C
- In addition to the standard equipment fitted on your machine, many options are available, such as: road lighting, stop lights,
rotating beacon light, reverse lights, front worklight, rear worklight, boom head worklight, etc.
(depending on machine model) .
- The operator must take into account the operating conditions to specify the machine's signaling and lighting equipment.
Contact your dealer.
- Take into account the climatic and atmospheric conditions of the site of utilization.
• Protection against frost ( MAINTENANCE: LUBRICANTS AND FUEL).
• Adaptation of lubricants
(consult your dealer) .
• Engine filtration ( MAINTENANCE: FILTER CARTRIDGES AND BELTS).

IMPORTANT

For operation under average climatic conditions, i.e. between -15°C and +35°C, the lubricants are filled in the factory.
For operation under more severe climatic conditions, before starting up, drain all circuits, then fill using lubricants suitable for the ambient temperatures.
The same applies to the coolant.
- A machine operating in an area without fire extinguishing equipment must be equipped with an individual extinguisher.
Solutions exist, consult your dealer.

IMPORTANT

Your machine is designed for outdoor use under normal atmospheric conditions and indoor use in suitably aerated and ventilated premises.
It is prohibited to use the machine in areas where there is a risk of fire or which are potentially explosive (e.g. refineries, fuel or gas depots, stores of inflammable products,
etc.).
Special equipment is available for use in such areas (ask your dealer for information).
647866 M1 (A012021) TMT ... K ST5 S1

Manitou TMT 25 I K ST5 S1 Specifications

General

Brand	Manitou
Model	TMT 25 I K ST5 S1
Category	Forklifts
Language	English