1 - 10
INSTRUCTIONS FOR THE OPERATOR
INTRODUCTION
IMPORTANT
The risk of accident while using, servicing or repairing your machine can be reduced if you follow the safety instructions and preventive measures detailed in this manual.
Failure to respect the safety and operating instructions, or the instructions for repairing or servicing your machine may lead to serious, even fatal accidents.
In order to reduce or avoid any danger with a MANITOU-approved attachment, follow the instructions
(
ADAPTABLE ATTACHMENTS AVAILABLE ON THE RANGE:
INTRODUCTION).
- Only the operations and maneuvers described in this operator's manual must be performed. The manufacturer cannot
predict all possible risky situations. Consequently, the safety instructions given in the operator's manual and on the
machine itself are not exhaustive.
- At all times, as an operator, you must envisage, within reason, the possible risk to yourself, to others or to the machine
when you use it.
GENERAL INSTRUCTIONS
A - INSTRUCTION MANUAL
- Read the operator's manual carefully.
- The operator's manual must always be in good condition and in the place provided for it on the machine.
- You must report any plates and stickers which are no longer legible or which are damaged.
B - AUTHORIZATION FOR USE IN FRANCE
(or see current legislation in other countries)
- Only qualified, authorized personnel can use the machine. This authorization is given in writing by the appropriate person
in the establishment where the machine is to be used and must be carried permanently by the operator.
- The operator is not empowered to authorize the driving of the machine by another person.
C - MAINTENANCE
- The operator must immediately advise his superior if his machine is not in good working order or does not comply with
the safety notice.
- The operator is prohibited from carrying out any repairs or adjustments himself, unless he has been trained for this
purpose. He should therefore keep the machine perfectly clean.
- The operator is responsible for carrying out daily maintenance operations ( MAINTENANCE: 10H - DAILY MAINTENANCE).
- For the safety of the operator, maintenance must be carried out with the engine off and the ignition key removed.
- The operator is responsible for deciding and adjusting the frequency of cleaning needed to prevent the risk of fire ensuing
from the build-up of flammable material(s).
- The operator should pay special attention to all the areas of the machine where these high-risk materials are likely to
accumulate.
D - TIRES
- The operator must ensure tires are appropriate for the type of ground ( DESCRIPTION: TIRES). Optional solutions are
available, please consult your dealer.
• SAND tires.
• FARM tires.
• Snow chains.
- In the event of tire replacement, use tires authorized by MANITOU that are the same type and dimensions. Using different
tires voids the machine's type approval and you may be liable.
- If you are replacing just one of the machine's tires (e.g. because it is damaged), we recommend choosing a tire with the
same degree of wear as the remaining tires so as not the damage the transmission's kinematic chain.
IMPORTANT
Do not use the machine if the tires are damaged or excessively worn, because this could put your own safety or that of others at risk, or cause damage to the machine itself.
The fitting of foam inflated tires is prohibited and is not guaranteed by the manufacturer unless with prior authorization.
647866 M1 (A012021)
TMT ... K ST5 S1
To Next Page
Loading...
Need help?
General