1 - 7
- Our machines comply with Directive 2004/108/CE concerning electromagnetic compatibility (EMC), and with the
corresponding harmonized standard EN 12895. Their correct operation is no longer guaranteed if they are used within
areas in which the electromagnetic fields exceed the limit specified by this standard (10 V/m).
- Directive 2002/44/CE requires company managers to not expose their employees to excessive vibration doses. There is
no recognized code of measurement for comparing the machines of different manufacturers. The actual doses received
cannot therefore be measured under actual operating conditions at the user's premises.
- The following are some tips for minimizing these vibration doses:
• Select the most suitable machine and attachment for the intended use.
• Adapt the seat adjustment to the operator's weight
(depending on machine model)
and maintain it in good condition, as well
as the cab suspensions. Inflate the tires in accordance with recommendations.
• Ensure that the operators adapt their operating speed to suit the conditions on site.
• As far as possible, arrange the site in such a way as to provide a flat running surface and remove obstacles and harmful
potholes.
C - MODIFYING THE MACHINE
- For your safety and that of others, you must not change the structure and settings of the various components of your
machine (hydraulic pressure, calibrating limiters, engine speed, addition of extra equipment, addition of counterweight,
unapproved attachments, alarm systems, etc.) yourself. In this event, the manufacturer cannot be held responsible.
D - FRENCH ROAD TRAFFIC RULES
(or see current legislation in other countries)
- Only one certificate of conformity is issued. It must be kept in a safe place.
- The driving of non "EC tractor" type-approved machines on the public highway is subject to the provisions of the Highway
Code relating to special machines, defined in Article R.311-1 of the Highway Code, in category B of the Equipment Order
of 20 November 1969 that determines the procedures applicable to special machines. The machine must be fitted with
an operating license plate.
- The driving of "EC tractor" type-approved machines on the public highway is subject to the provisions of the highway
code regarding agricultural tractors, defined in Article R.311-1 of the highway code. The machine must be licensed.
SPECIAL INSTRUCTIONS APPLICABLE TO "EC TRACTOR" TYPE-APPROVED MACHINES
- All type-approved machines are supplied with an "EC tractor" certificate complying with Directive 2003/37/CE, to be
retained by the owner, and a page of administrative details together with a CNIT number (national type approval code)
for registration at the prefecture.
- The owner of the machine is responsible for carrying out the necessary procedures for obtaining the vehicle registration
document within the time limit defined by the regulations.
- The operator must hold an HGV license, unless granted an exemption.
- The machine must be driven on the public highway in accordance with the instructions given in the manual supplied
with the machine (Gross weight, Gross combination weight, towing load, axle loads, maximum speeds, etc. according
to the type/version). The operator must be in possession of the machine’s registration document.
IMPORTANT
When towing a trailer or agricultural equipment, the traveling speed of the machine is limited to 25 km/h. In this case, a "25" disc must be affixed to the rear of the convoy.
E - PROTECTING THE CAB
- All machines comply with the requirements of standard ISO 3471 (wheel loader code) regarding cab rollover protection
(ROPS) and standard ISO 3449 (Level II) regarding the protection of the cab against falling objects (FOPS).
- "EC TRACTOR" type-approved machines comply, in addition, with Directive 79/622/CE (OCDE Code 4) regarding cab
rollover protection (ROPS).
IMPORTANT
Structural damage or overturning, a modification, changes or a poorly executed repair can reduce the protective efficiency of the cab, canceling its compliance.
Do not perform welding or drilling on the cab structure.
Consult your dealer to determine the limits of this structure without canceling its compliance.
647866 M1 (A012021)
TMT ... K ST5 S1
To Next Page
Loading...
Need help?
General