1 - 12
OPERATING INSTRUCTIONS UNLADEN AND LADEN
A - BEFORE STARTING UP THE MACHINE
- Carry out daily maintenance ( MAINTENANCE: 10H - DAILY MAINTENANCE).
- Make sure that the driver's cab is clean, particularly the floor and floor mat. Check that no movable object may hinder
the operation of the machine.
- Make sure the lights, turn signals and windshield wipers are working properly.
- Make sure the rear-view mirrors are in good condition, clean and properly adjusted.
- Make sure the horn works.
B - DRIVER'S OPERATING INSTRUCTIONS
- Whatever his experience, the operator is advised to familiarize himself with the position and operation of all the controls
and instruments before operating the machine.
- Wear clothes suitable for driving the machine, avoid loose clothing.
- Make sure you have the appropriate protective equipment for the task to be performed.
- Prolonged exposure to high noise levels may cause hearing problems. It is recommended to wear ear muffs to protect
against excessive noise.
- Always face the driver's cab when getting in and out and use the handle(s) provided for this purpose. Do not jump out
of the machine.
- Remain alert at all times when using the machine. Do not listen to the radio or music using headphones or earphones.
- Never operate the lift truck when hands or feet are wet or soiled with greasy substances.
- For increased comfort, adjust the seat to your requirements and adopt the correct position in the driver’s cab.
IMPORTANT
Under no circumstances must the seat be adjusted while the machine is moving.
- The operator must always be in his normal position in the driver’s cab: Arms and legs, and generally any part of the body,
should be kept inside the driver’s cab of the machine.
- The safety belt must be worn and adjusted to the operator's size.
- The control units must never in any event be used for any other than their intended purposes (e.g. Climbing onto or
down from the machine, coat hanger, etc.).
- If the control components are fitted with a forced operation (lever lock) device, it is forbidden to leave the cab without
first putting these controls in neutral.
- It is prohibited to carry passengers either on the machine or in the cab.
C - ENVIRONMENT
- Comply with site safety regulations.
- If you have to use the machine in a dark area or at night, make sure it is equipped with worklights.
- During handling operations, make sure that no one is in the way of the machine and its load.
- Do not allow anybody to come near the working area of the machine or pass beneath an elevated load.
- When using the machine on a transverse slope, before lifting the boom, follow the instructions (
INSTRUCTIONS FOR
HANDLING A LOAD: D - TRANSVERSE ATTITUDE OF THE MACHINE).
- Traveling on a longitudinal slope:
• Drive and brake gently.
• Moving without load: forks or attachment facing downhill.
• Moving with load: Forks or attachment facing uphill.
- Take into account the machine’s dimensions and its load before trying to negotiate a narrow or low passageway.
- Never move onto a load bridge without having first checked:
• That it is suitably positioned and made fast.
• That the unit to which it is connected (wagon, truck, etc.) will not shift.
• That this bridge is prescribed for the total weight of the machine, laden or unladen.
• That this bridge is prescribed for the size of the machine.
647866 M1 (A012021)
TMT ... K ST5 S1
To Next Page
Loading...
Need help?
General