Manitou TMT 25 I K ST5 S1 - Rear Worklight; Rear-View Mirrors; Reversing Horn; Rotating Beacon

27 - REAR WORKLIGHT
Except for TMT 27 P K ST5 S1 (Standard)
The rear worklight comes on automatically in reverse gear.
28 - ROTATING BEACON
NOTE: As an option, an LED rotating beacon light or an LED flashing light is available.
29 - REVERSING HORN
30 - REAR-VIEW MIRRORS
31 - ENGINE IMMOBILIZER SYSTEM
This system calls for the creation of a login for the operator.
NOTE: For more information, contact your dealer.
IDENTIFICATION BY CODE
- Switch on the ignition, LED1 comes on.
- Enter the ID code and confirm by pressing the "V" key. LED2 lights up green.
- Start the engine immediately.
NOTE: In the event of incorrect entry or if it takes too long to start, the LED2 comes
on in red. Press the button "X" and wait for 10seconds before re-entering the
identification code.
IDENTIFICATION BY CARD
- Switch on the ignition, LED1 comes on.
- Present the ID card. A beep confirms that the card has been read and LED2 lights up green.
- Start the engine immediately.
NOTE: If it takes too long to start, the LED2 comes on in red. Press the button "X" and wait for 10seconds before swiping
the identification card again.
2 - 46
27
28
X
V
1
2
647866 M1 (A012021) TMT ... K ST5 S1