1 - 20
SETTING DOWN A HIGH LOAD ON TIRES
- Approach the load in the transport position in front of the stack (fig. F6).
- Apply the parking brake and place the forward/reverse selector in neutral.
- Raise and extend the boom (1) (2) until the load is above the stack, monitoring the
longitudinal stability limiter and warning device (
INSTRUCTIONS FOR HANDLING
A LOAD: C - LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE). If necessary,
move the machine (3) forward (fig. F7), driving very slowly and carefully.
- Place the load in a horizontal position and lay it down on the pile by lowering and
retracting the boom (1) (2) in order to position the load correctly (fig. F8).
- If possible, release the forks by alternately retracting and raising the boom (1) (fig.
F9). Then set the forks into transport position.
- If this is not possible, reverse the machine (1), maneuvering very slowly and carefully
to release the forks (fig. F10). Then set the forks into transport position.
G - PICKING UP AND SETTING DOWN A HIGH LOAD ON STABILIZERS
Depending on machine model
IMPORTANT
You must not raise the boom if you have not checked the transverse attitude of the machine
(
INSTRUCTIONS FOR HANDLING A LOAD: D - TRANSVERSE ATTITUDE OF
THE MACHINE).
REMINDER: Make sure that the following operations can be performed with good visibility ( OPERATING INSTRUCTIONS
UNLADEN AND LADEN: D - VISIBILITY).
The stabilizers are used to optimize the machine's lifting performance (
DESCRIPTION: INSTRUMENTS AND CONTROLS).
F6
1
2
3
F7
1
2
F8
1
F9
1
F10
647866 M1 (A012021)
TMT ... K ST5 S1
To Next Page
Loading...
