Manitou TMT 25 I K ST5 S1 - Page 20

1 - 16
SAFETY INSTRUCTIONS
- Operators driving on the public highway must comply with current highway code legislation.
- The machine must comply with current road legislation. If necessary, there are optional solutions. Contact your dealer.
INSTRUCTIONS
- Make sure the revolving light is in place, switch it on and verify its operation.
- Make sure the lights, turn signals and windshield wipers are working properly.
- Switch off the worklights if the machine is fitted with them.
- Always move the machine with the forks or attachment in the transport position, i.e. approximately
300mm from the ground:
• LADEN, DRIVE WITH THE BOOM RETRACTED AND THE CARRIAGE TILTED BACK.
• UNLADEN, THE BOOM MUST BE FULLY TELESCOPED.
- Raise the stabilizers to their maximum extent
(depending on machine model) .

IMPORTANT

Never coast in neutral (forward/reverse selector or gear lever in neutral or transmission cut-off button pressed) to preserve the machine's engine brake.
Failure to observe this instruction on a slope will lead to excessive speed, which may make the machine uncontrollable (steering, brakes) and cause serious mechanical
damage.
DRIVING THE MACHINE WITH A FRONT-MOUNTED ATTACHMENT
- You must comply with current regulations in your country, covering the possibility of driving on the public highway with
a front-mounted attachment on your machine.
- If road legislation in your country authorizes circulation with a front-mounted attachment, you must at least:
• Protect and report any sharp and/or dangerous edges on the attachment ( ADAPTABLE ATTACHMENTS AVAILABLE
ON THE RANGE: ATTACHMENT GUARDS).
• The attachment must not be loaded.
• Make sure that the attachment does not mask the lighting range of the forward lights.
• Make sure that current legislation in your country does not require other obligations.
574317
647866 M1 (A012021) TMT ... K ST5 S1