C3-STATISTICS
This page gives you access to the statistics.
NOTE: Only the dealer can access these settings
C-MAINTENANCE
This page gives access to 3 maintenance sub-menus.
- Use
or to select a sub-menu, then press on to confirm the selection.
• C1-MAINTENANCE
• C2-OVERLOAD TEST
• C3-STATISTICS
C1-MAINTENANCE
This page gives access to:
• Disabling of automatic regeneration of the particulate filter (
"WARNINGS
AND FAULTS" PAGE - ENGINE FAULTS).
• Activation of stationary machine regeneration following engine fault alerts
("WARNINGS AND FAULTS" PAGE - ENGINE FAULTS).
C2-OVERLOAD TEST
This page gives access to:
• Periodic testing of overload sensor operation and adjustment
(3-MAINTENANCE: 10H - LONGITUDINAL STABILITY LIMITER AND WARNING
DEVICE)
• The emergency mode of the forward/neutral/reverse gear selector
(3-MAINTENANCE: OCCASIONAL OPERATION).
D-FAULT LOG
This page shows the history of the faults that have occurred on the machine.
NOTE: Only the dealer can access these settings
2 - 31
D
C
C1
C3
C2
647866 M1 (A012021)
TMT ... K ST5 S1
To Next Page
Loading...
Need help?
General