Manitowoc GROVE GMK 4100 - Before driving with the rigged crane; Driving the rigged truck crane

Driving with rigged crane
8.4 Before driving with the rigged crane
Lattice extension operating instructions 3 112 441 en 8 - 3
GMK 4100/4100-L/5095
11.01.2008
8.4 Before driving with the rigged crane
• Check the tyre pressure and the wind speed; à Operating instructions of
the truck crane
.
• Switch off the slewing gear; à Operating instructions of the truck crane.
• Put the truck crane on the wheels; à Operating instructions of the truck
crane
. The suspension remains switched off.
• For reasons of safety, extend the outrigger beams as permitted by the
available space. The outrigger pads may not touch the ground while driv-
ing the crane.
8.5 Driving the rigged truck crane
Driving from the
driver's cab
• Switch to the lowest starting gear; à Operating instructions of the truck
crane
. In this way you can prevent the transmission from upshifting and
keep the speed to a minimum.
• Switch on the separate steering; à Operating instructions of the truck
crane
.
If necessary, you can
– Switch on the longitudinal differential locks
– Switch on the transverse differential locks
s
G
Risk of accidents when driving the truck crane from the driver's cab with a
raised load
Drive the truck crane with a raised load only from the crane cab. You must
be able to operate the crane at any time in the event of an emergency.