Mannayan Trikombin - Application List Columns; Adding Programs to Application List

© 2019 Mannayan GmbH + Co KG Page 36 User Manual Trikombin
9. Button to de-activate (disable) the selected frequency program (or to activate
(enable) it, if it was already de-activated). A de-activated entry is displayed in grey
and will be ignored during execution.
10. Button to edit some attributes of the selected frequency program
11. Display of the total execution time of all listed frequency programs
7.3.3 Contents of the Columns of the Application List
The columns of the application list display the following data:
• Prog
Number of the frequency program
• P
“Yes” is displayed when “Stop before start” was selected for the frequency program.
In this case, the execution of the application list will be paused before this frequency
program. This is useful, if e.g. the contents of the brass cups or the location of the
electrodes should be changed for the execution of this frequency program.
• T
Displays the execution time of the frequency program in minutes and seconds.
• Description
The description includes the following information:
o Name of the frequency program
o Changes made in comparison to the original frequency program
o Comment (if entered by the operator)
7.3.4 Adding Frequency Programs to the Application List
Frequency programs can either be added to the application list by means of the Testing
Mode (see chapter 7.2.7 Adding Frequency Programs to the Application Mode) or – if the
number of the frequency program is known – as follows:
• Enter the number of the frequency program via the keypad. The dialogue “Add
program to Application” appears on the screen.
• Select if you wish or do not wish to load a user-defined program via pressing the
“User” key (the key above “Enter”) or tapping the corresponding field of the dialogue.
• Enter the desired execution time.
• Select “Stop before start” if the execution should stop before this frequency program,
which allows e.g. to change the contents of the brass cups or to place the electrodes
differently.
• Optional: enter a comment. It will be displayed in the application list.
• Press the “Enter” key or tap on the corresponding button of the dialogue.