Mannayan Trikombin - Removing Chains from Testing

© 2019 Mannayan GmbH + Co KG Page 46 User Manual Trikombin
7.6.5 Removing a Chain from the Testing Mode
If you want to remove all chains, which have been added to the Testing Mode, proceed as
follows:
1. Tap the button “Libraries...”. The menu for the libraries opens.
2. Tap on “Remove all chains”.
3. The device shows a message to confirm that you want to remove all selected chains.
4. Confirm the message by tapping “Yes”.
If you want to remove only one chain, which has been added to the Testing Mode, proceed
as follows:
1. Tap the button “Libraries...”. The menu for the libraries appears on the touchscreen.
2. Tap on “Selected chains...”. The dialogue “Selected chains” opens.
3. Select the desired chain with the rotary encoder.
4. Tap the button “Remove”.
5. Close the dialogue.
All selected chains will also be removed when a new session is started.