User Manual Trikombin Page 43 © 2019 Mannayan GmbH + Co KG
3. If you want to save the frequency programs as a new sequence:
• Tap on the field “Name of new sequence”. The touchscreen keypad opens.
• Enter the desired name of the new sequence.
• Tap on “Ok” to close the touchscreen keypad.
• Tap on “Add” to close the dialogue “Save chip card sequence”. The sequence will
be saved under the specified name.
4. If you want to replace an existing sequence:
• Select the desired sequence with the rotary encoder.
• Tap on the button “Replace existing”. The dialogue “Save chip card sequence”
will be closed and the selected sequence will be replaced with the frequency
programs of the application list.
Always the entire content of the application list will be saved to the chip card. Entries that
shall not be saved must first be removed or deactivated. Select the affected entry via the
rotary encoder and tap on the button “Disable” or “Remove”. If you solely want to deactivate
or remove one subprogram of a chain, first tap the arrow button to the right and select via
the rotary encoder the desired program.
To Next Page
