ECODRIVE DKC01.1/DKC11.1 Drive Controllers
3-6 Description of Diagnostic Letters C... and A... DOK-ECODRV-ASE-02VRS**-WAR1-EN-P • 07.96
C214 Velocity Data Scaling Error
Cause:
The display format of the velocity data can be set with the help of the
scaling parameter. The internal drive format of the velocity data is
dependent on the applied feedback and the controller resolution. The
factor for the conversion of the velocity data from the internal drive format
into the display format (or the reverse process) is outside of the workable
area.
Remedy:
Connect the drive with a PC and start DriveTop. In the dialog box
„Scaling/Mechanical system" select a scaling setting.
Should another scaling installation other than one from DriveTop be used,
then the following parameters must be checked.
• • S-0-0044, Velocity Data Scaling Type
• • S-0-0045, Velocity Data Scaling Factor
• • S-0-0046, Velocity Data Scaling Exponent
• • S-0-0121, Input Revolutions of Load Gear
• • S-0-0122, Output Revolutions of Load Gear
• • S-0-0123, Feed Constant
C215 Acceleration Data Scaling Error
Cause:
The display format of the acceleration data can be set with the help of the
scaling parameter. The internal drive format of the acceleration data is
dependent on the applied feedback and the controller resolution. The
factor for the conversion of the acceleration data from the internal drive
format into the display format (or the reverse process) is outside of the
workable area.
Remedy:
Connect the drive with a PC and start DriveTop. In the dialog box
„Scaling/Mechanical system" select a scaling setting.
Should another scaling installation other than one from DriveTop be used,
then the following parameters must be checked.
• • S-0-0160, Acceleration Data Scaling Type
• • S-0-0161, Acceleration Data Scaling Factor
• • S-0-0162, Acceleration Data Scaling Exponent
• • S-0-0121, Input Revolutions of Load Gear
• • S-0-0122, Output Revolutions of Load Gear
• • S-0-0123, Feed Constant
To Next Page
Loading...
Need help?
General