ECODRIVE DKC01.1/DKC11.1 Drive Controllers
DOK-ECODRV-ASE-02VRS**-WAR1-EN-P • 07.96 Description of Diagnostic Letters C... and A... 3-9
C400 Switch from Operational to Parameter Mode
Description:
The command for transition is in parameter mode. While editing the
parameters that can be edited only in parameter mode, this command
must be processed.
C401 Active Drive, Transition is not Permissable
Cause:
The command C400 “switch from operational to parameter mode" would
be started without the control enable being activated.
Remedy:
End the command and turn off the drive enable, then the command can
be started from the beginning.
C500 Reset Class 1 Diagnostic
Description:
The command for erasing errors, "S-0-0099, Reset Class 1
Diagnostics" was activated via the connected control system. All internal
drive errors are erased. However, the errors must have been previously
corrected.
C600 Drive Controlled Homing Procedure
Description:
The command "S-0-0148, Drive Controlled Homing Procedure" was
activated via the connected control system. The control drive
automatically performs the internal drive homing procedure. Give the
drive a start command to do this. Prior to this the drive must be enabled
and in motion.
C601 Homing Procedure not Possible without Drive Enable
Cause:
The command would be started without drive enable being turned on.
Remedy:
1. Enable Drive
2. Restart the command
To Next Page
Loading...
Need help?
General