Mannesmann INDRAMAT ECODRIVE DKC01.1 User Manual

ECODRIVE DKC01.1/DKC11.1 Drive Controllers
4-2 Exchanging Drive Components DOK-ECODRV-ASE-02VRS**-WAR1-EN-P • 07.96
Position of the identification plates:
The identification plate for the DKC drive controller is found on the front
side of the casing. It contains all data related to this drive.
The identification plate for MKD motors is on the right side of the motor
(when looking at the motor shaft with the motor connection box on top).
Assembled cables are supplied with a label (cable mark) that carries the
cable number and the length of the assembled cable.
Specifications for Model Label - Base Equipment
DKC _._ - _ _ _ _ - _
S.No.: _ _ _ _ _ _ -
_ _ _ _ _ A _ _ S _ _
INDRAMAT - Cable
IKS _ _ _
No.
Length: m
Pre-Formed Engine Performance Cable
1)
2)
2)
INDRAMAT - Cable
IKG _ _ _
No.
Length: m
Pre-Formed Engine Feedback Cable
1)
MKD _ _ _ _ - _ _ _ - _ _ _ _ _ _ / _ _ _ _
1. Pre-formed cables made by INDRAMAT (with connector) are identified with
a
model label. The label provides the ordering information (IKS 103 for the
Feedback cable, for instance).
2. If cables are ordered without the connector, refer to the stamp on the cable
sheathing (Engine Feedback Cable IN 488, for instance).
AP5001F1.DRW
Figure 4-1: Type Description of the Drive Components

Mannesmann INDRAMAT ECODRIVE DKC01.1 Specifications

General

Brand	Mannesmann
Model	INDRAMAT ECODRIVE DKC01.1
Category	Controller
Language	English