ECODRIVE DKC01.1/DKC11.1 Drive Controllers
4-6 Exchanging Drive Components DOK-ECODRV-ASE-02VRS**-WAR1-EN-P • 07.96
Operating mode used:
Error Report
for DKC and MKD digital AC servodrives
Error report
Company: Date:
Error condition: Causes: Accompanying phenomenon:
is continually present
during installation
occurs sporadically
occurs after approx. hours
occurs during vibration
unknown
connection error
external cause
mechanical damage
loose power connection
condensation in device
mechanical system problems
power supply failure
(
24 V
ext.
)
control system failure
motor failure
cable break
defective ventilator
is the switch box
air-conditioned? Y / N
Have there been similar
errors in the same shaft before?
How often:
Did the errors always occur on
specific days or at specific times?
additional information:
Supplementary information:
Details of the machine on which the error occurred:
How was the error detected:
Machine manufacturer:
Machine number:
T
ype: Hours of operation:
Installation date:
Machine control system manufacturer and type:
Designation of the machine shaft in which the error occurred:
Location:
Department:
T
elephone:Name:
Details of the faulty drive
PI0001d1.drw
H1
Enter the
display at
the time of
the error
Serial number:
Motor type:
Motor specifics:
Power supply:
single-phase
three-phase
Model specifics
Basic device
INDRAMA T GmbH
Bgm.-Dr .Nebel-Straße 2
Abt. QSP
D-97816
Lohr am Main
DKC _._ - _ _ _ _ - _
S.No.: _ _ _ _ _ _ -
Firmware details: FWA-ECODRV- - -
This error report helps clarify errors and their causes. It is imperative to also find hidden, sporadic, or application induced
problem and eliminate them.
- Always send error reports with repairs.
- In other cases send error reports to the appropriate INDRAMAT location or to the INDRAMAT Quality Assurance address
printed in the address field.
INDRAMAT would like to thank you for by providing you with a quick and thorough turnaround.
Figure 4-3: Defect report
To Next Page
Loading...
Need help?
General