43
D00619EN - v0 SWING OPERATOR - INSTALLATION MANUAL
10.2 Installation Checklist
Compliance with safety requirements is a primary
objective for manusa, given that hundreds of thou-
sands of people in more than 70 countries pass
through our doors daily.
Risk assessment for manusa doors is not
limited to the design and industrialisation ac-
tivities carried out at our factory, but encom-
passes the entire useful life of our products,
guaranteeing the health and safety of the us-
ers at each stage of the lifecycle of the door.
Please place here the identifying
sticker for the installation
Mechanical/Electrical Elements
Compliance Non-
compliance
Not
applicable
Observations
Fixing the operator on-site
Position of the Dragging / Pushing operator
Cover and external caps
Axis and arm
Fasteners and suspension of leaves
Spring load level (EN4-EN5-EN6)
Condition of the leaves
Wiring
Low Energy parameter
Push & Go parameter
Dragging / Pushing parameter
Actuator S (spring) / M (motor) parameter
Acceleration parameter
Waiting times parameter
Lock parameter
Auxiliary I/O configuration
Peripheral controls (selector/outside key switch…)
Safety and Control Elements:
Compliance Non-
compliance
Not
applicable
Observations
Sistemas de accionamiento (radar…)
Sensores de seguridad
Documentation:
Compliance Non-
compliance
Not
applicable
Observations
Instructions manual submitted
Works delivery certificate submitted
Maintenance contract submitted
To Next Page
Loading...
