Marantz MR2020 - Program Timer Execution

— Program Timer Execution —
— Checking the Program Timer Contents —
-Press the TIMER ON/OFF button once.
The current program timer contents are displayed in se-
quence. (PRG-1 then PRG-2).
— Skipping only the Next "DAILY" Operation —
Press the TIMER ON/OFF button successively twice or more
Each press switches the display contents as shown be-
low. Press until only the timer program(s) that you want
to execute are displayed.The fact that a timer program is
not displayed does not mean that it is cleared.
TIMER (1) (2)
Timer programs 1 and 2 are executed.
}
TIMER (7)
Only timer program 1 is executed.
|
TIMER (2)
Only timer program 2 is executed.
No timer program is executed.
Notes
* Timer programs can be executed only when power is off.
* To listen to radio with program timer, tune the frequency of
the desired station before turning power off.
** To play a CD with program timer, set the desired CD before
turning power off.
Set the optimum listening volume before turning power off.
** If no CD has been set at the moment power is turned on by
the program timer, the radio is played instead.
** The adjusted time of the day is displayed as the time (in the
12-hour or 24-hour system).
* It is not possible to play the AUX input function with program
timer.
** {tis possible to check the program only when the top panel is
closed.
*
ENGLISH
— Operation in Case Two Timer Programs are Overlapped —
Note
* This unit can adjust two timer programs PRG-1 and PRG-2.
However, if the two timer programs are overlapped, note
that the unit does not operate as intended.
PRG-1
PRG-2
Time Time
>
ON OFF ON
ON OFF ON
OFF
OFF
©: Valid operation
x: Invalid operation
©: Valid operation
x: Invalid operation
PRG-1
PRG-2
ON OFF ON OFF
ON OFF ON OFF
©: Valid operation
x: {Invalid operation
PRG-1 pee
PRG-2
Time Time
al al
ON OFF ON OFF
ON OFF ON OFF
©: Valid operation
x: Invalid operation