Marantz MR2020 - Page 9

=
”
a
2)
z
ul
— Connection of AM loop antenna (provided) - — Attachment of speaker legs —
@ Assemble the provided AM loop antenna as shown below @ There are 8 speaker legs(2 sets of 4) included with the speakers.
before connecting it.
To rear panel ANTENNA jack wT 2 pe
Please refer to the diagram below to attach 4 legs to the bottom
of each speaker.
Insert section A into B
Notes:
AM loop antenna
* Install the AM loop antenna in a position where the best re- o----Attachment point of
speaker legs
ceiving condition can be obtained.
* When the AM loop antenna is installed near a TV, the receiv-
ing condition may be deteriorated due to interference from
the TV. In this case, install the AM loop antenna as apart as
possible from the TV. Notes:
* Connect the cable from the AM loop antenna to the ANTENNA ~~ Remove dirt or layer of oil etc., before attaching the legs.
jack by checking the orientation of the plug. * Attach legs left to right, symmetrically.
— Connection of speakers (provided) —
* The provided speakers are designed magnetism-proof so
they can be installed near a TV. However, they may cause
color irregularities on the screens of some TV models. In this
case, install the speakers at a larger distance from the TV.