Marantz NR1504 - Surr.parameter

121
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Surr.Parameter
You can adjust the surround audio sound field eects to match your
preferences.
The items (parameters) that can be adjusted depend on the signal
being input and the currently set sound mode. For details on the
adjustable parameters, see “Sound modes and surround parameters”
(vpage182).
%
•Some setting items cannot be set while playback is stopped. Make the settings
during playback.
2 Home Theater EQ
Gently softens the upper treble range of movie soundtracks to reduce
possible harshness and improve clarity.
On : “Home Theater EQ” is used.
O (Default) : “Home Theater EQ” is not used.
2 Loudness Mngmt
This sets whether to output as specified in “Dynamic Comp.” or output
directly without compressing the dynamic range of audio recorded in
the disc.
On (Default) : Outputs using the settings made in “Dynamic Comp.”
and “Dialogue normalization function” (vpage 154)
are enabled.
O : “Dynamic Comp.” settings and “Dialogue Normalization” are
disabled, and the signals on the disk are output as is.
%
•This can be set in the Dolby TrueHD mode.
2 Dynamic Comp.
Compress dynamic range (dierence between loud and soft sounds).
Auto : Automatic dynamic range compression on/o control according
to source.
Low / Medium / High : These set the compression level.
O : Dynamic range compression is always o.
%
•You can set “Auto” only for the Dolby TrueHD source.
•The default setting is “O”. When the input signal is Dolby TrueHD source,
the default setting is “Auto”.