Marantz NR1504 - Connecting an External Control Device; Remotely Connecting Marantz Devices

40
Appendix
TipsSettingsPlayback
Contents
Front panel Display Rear panel IndexRemote
Connections
Connecting an external control device
Remotely connecting Marantz devices
2 Performing operations by RC on this unit
without visual contact
You can connect an external IR receiver to the REMOTE CONTROL
connectors to perform operations on this unit with the supplied remote
control unit without visual contact. This might be necessary if the unit
is hidden in a cupboard or corner, so you can't directly point with the
remote control unit to the device.
To do this, disable the remote control signal receiving function
(vpage111 “Remote lock function”).
RC OUT
IR receiver
NOTE
•When the remote control signal receiving function is disabled, you can not perform
operations with the remote control unit.
2 Remotely connecting Marantz devices
When you are using a Marantz device other than this unit that supports
remote connection, you can transmit remote control signals just by
connecting the device to the REMOTE CONTROL IN/OUT connector
with a monaural cable.
Set the remote control switch located on the rear panel of the connected
audio component to “EXTERNAL” or “EXT.” to use this feature.