Marantz NR1504 - Audyssey

125
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
2 Limit
Make a setting for maximum volume.
60 (–20dB) / 70 (–10dB) / 80 (0dB)
O (Default)
2 Power On Level
Define the volume setting that is active when the power is turned on.
Last (Default) : Use the memorized setting from the last session.
Mute : Always use the muting on condition when power is turned on.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
2 Mute Level
Set the amount of attenuation when muting is on.
Full (Default) : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
–20dB : The sound is attenuated by 20 dB down.
Audyssey
Set Audyssey MultEQ®, Audyssey Dynamic EQ® and Audyssey Dynamic
Volume®. These can be selected after Audyssey® Setup has been
performed. For additional information on Audyssey technology, please
see page187.
%
•“MultEQ®”, “Dynamic EQ” and “Dynamic Volume” settings are stored for each
input source.
•“MultEQ®”, “Dynamic EQ” and “Dynamic Volume” cannot be set when the sound
mode is set to “DIRECT” or “PURE DIRECT”.
2 MultEQ
®
MultEQ® compensates for both time and frequency characteristics of
the listening area based on Audyssey® Setup measurement results.
Selection is done from three types of compensation curves. We
recommend the “Audyssey” setting.
Audyssey (Default) : Optimize the frequency response of all speakers.
Audyssey Byp.L/R : Optimize frequency response of speakers except
front L and R speakers.
Audyssey Flat : Optimize frequency response of all speakers to flat
response.
Manual EQ : Apply frequency response set with “Manual EQ”
(vpage127).
O : Turn “MultEQ®” equalizer o.
%
•When using headphones, “MultEQ®” is automatically set to “O”.