Marantz NR1504 - Front Panel Display Rear Panel

184
TipsSettingsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Appendix
z1 This item can be selected when a Dolby TrueHD signal is played.
z2 This item can be selected when a Dolby Digital or DTS signal is played.
z3 This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z4 During playback in PURE DIRECT mode, the surround parameters are the same as in DIRECT mode.
z5 This setting is available when “Subwoofer Mode” (vpage148) in the menu is set to “LFE+Main”.
z6 This item cannot be set when “Dynamic EQ” (vpage126) is set to “On”.
z7 This item cannot be set when Audyssey® Setup (Speaker Calibration) has not been performed.
z8 This item cannot be set when “MultEQ®” (vpage125) is set to “O” or “Manual EQ”.
z9 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.