53
The m.u. consist is now available for use.
The 2nd controller can now be used for
another locomotive or m.u. consist.
Deleting a Locomotive or M.U. Consist
The locomotive or m.u. consist
is removed from the locomotive
list and is no longer available for
use. It must be entered again.
If you have not previously carried
out a data protection procedure
(backup), the data just deleted are
irretrievably lost and can be gene-
rated only by entering and setting
them up again.
You can process the m.u. consist with this
tool. Add or remove locomotives as in the
2nd step above.
!Now and then you should generate a data backup in the menu “setup“. You should always do this
data backup after changes to data. You can then produce the old status from this backup and thereby
have your locomotive list available again.
Turning off the Central Station:
Go to the “Setup“ menu
before turning the Central
Station off. Select “Shut-
down“ and confi rm the selection. The “Stop Button“ will light up
on the controller and the shutdown will begin. The Central Station
can be unplugged when the display goes off. The controller be-
gins to shut down. As soon as the door on the locomotive shed is
closed, the Central Station can be unplugged.
The motive power
consist has been
taken into the
locomotive list.
The motive power consist can
now be taken into the Control.
c
d
To Next Page
Loading...
Need help?
General
