58
76394 Hp1/Sh1
76371 Sh1
76392 Sh1
Now wait until only the
distant signal is blinking.
Then activate the home
signal to which the distant
signal is assigned.
Hp1/Hp2
c
c
d
d
If the signal begins to switch between the signal aspects, the programming procedure is completed.
Now press the “Stop“ button. The programming bracket can now be removed. Then press “Stop“ again.
The Central Station is now ready to be operated again.
Switch to the confi guration mode. Now, change the switching duration to 250 milliseconds (Step 12). This
is a long enough time for ordinary operation. Change to the operating mode and check to make sure all of
the functions of the signal just programmed are working correctly. If necessary, repeat the programming
procedure.
Programming Professional Quality Color Light Signals.
Set up on your Keyboard beforehand the signals to be programmed as described in Steps 1-13.
Enter the switching time at 1,000 milliseconds for the programming procedure. Now click on this
symbol and confi rm the messages that come afterward.
!Keep the programming bracket; it will be needed in the future for address changes.
76391 Hp1
76395
c
or
76393 Hp1/Hp2
76397
If a distant signal is mounted on the mast of a home signal, this distant signal must now also be
programmed.
Changing signal aspects will now blink in the active programming mode. Now press the signal
image for the professional quality color light signal set up on the Keyboard on the Central Station.
Press the “Stop“ button in order to interrupt the current and connect the signal to the main track or
to the programming track. Make sure that the wire bracket (programming bracket) surrounded with
cardstock is clipped onto the underside of the decoder. Turn the current back on by pressing the
“Stop“ button again.
! No locomotives may be run during the programming procedure. Please note that the
programming procedure will be stopped if there are no entries made within 30 seconds.
c
With a signal with more than 2 aspects other signal aspects will alternately blink.
The individual steps for these signals can be found in examples further down in the text.
d
The programming is now complete for a signal with 2 aspects. The remainder of the process can be
found further down in the text.
Hp1
c
d
c
c
c
Hp2
d
To Next Page
Loading...
