57
Important Note!
Before you turn the Central Station off, perform
the function “Shutdown“ in order to ensure that
all data has been saved. Turning off the Central
Station suddenly may cause loss of the last data
to be changed.
Confi rm or
enter a new
accessory
(starting at
Step Ö 4)
13
Confi rm entry
14
If the turnouts/signals are connected to k 83 decoders (item nos. 6083 or 60830) and the turnout/signal
setting does not correspond to the display, then the blue wires for the connection in question must
be swapped.
Checking Accessory Function
15
15.1
! If the solenoid accessory does not operate despite the correct
address, please check the wires at the track connection.
11
Set the switching duration: We recommend
a duration between 250 - 500 milliseconds.
Tip:
Basically, the addresses for the decoders can be used in mixed operation. You can decide by address
which protocol will be assigned to the latter and which protocol will be supported by the decoder.
You can thus use the Märklin professional quality color light signals in DCC operation also.
12
To Next Page
Loading...
Need help?
General
