Chapter 5 INSTRUCTIONS FOR USE 57
5.3.5.1 Standard Use Modes
Initial condition:
Connected measure
handle connected to an
electronic unit.
Acquisition mode:
Click
one of the two buttons
( blue) + Click ( blue).
Description:
Sending the measure to the electronic unit.
Send measure
WARNING
The transmission of the measure to the electronic unit is possible only if
the gauge is within range of the electronic unit where the Dongle is
installed.
If not, the measure is freezed until the connection is re-
established*; then the measure is sent to the electronic unit.
(*) Note:
If a key is pressed before sending to the electronic unit, the freezed
measurement is lost.
To Next Page
Loading...
