model no. 046-0266-0 | contact us 1-800-689-9928
30
CONNECT THE OPENER TO POWER
CONNECT THE OPENER TO POWER
Connect AC Power
Plug motor unit into grounded outlet. If a grounded outlet is not
available, contact a qualified electrician to install a proper outlet.
DO NOT ACTIVATE THE OPENER UNTIL INSTRUCTED.
Permanent Wiring/Remove Cover
Be sure the power cord is unplugged. Remove the screws from the
cover of the opener.
Permanent Wiring/Remove
the Power Cord
WARNING
If permanent wiring is required by your local code, have a licensed electrical contractor follow the
procedures outlined in this manual. Disconnect power to the circuit before removing cover.
• Be sure power is not connected to the opener and disconnect power to circuit before removing cover to
establish permanent wiring connection.
• Garage door installation and wiring must be in compliance with all local electrical and building codes.
• Never use an extension cord, 2-wire adaptor, or change plug in any way to make it fit outlet. Be sure the
opener is grounded.
• The opener has a grounded type plug for your protection and only fit into a grounding type outlet. Do not
change the plug in any way.
To Next Page
Loading...