model no. 046-0266-0 | contact us 1-800-689-9928
10
IMPORTANT INSTRUCTIONS
IMPORTANT INSTRUCTIONS
WARNING
To reduce the risk of severe injury or death:
1. READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.
2. Check with the door manufacturer to determine if additional reinforcement is required to support
the door prior to installation of the garage door opener.
3. Install garage door opener only on a properly balanced garage door. An improperly balanced door
could cause serious injury. Have a qualified service professional make repairs to garage door
cables, spring assemblies and other hardware before installing the opener.
4. Remove all ropes and disable all locks connected to the garage door before installing opener.
5. Mount the emergency release handle 6' (1.8 m) above floor.
6. Do not connect the opener to source of power until this manual instructs you to do so.
7. Locate the wall console or wall console:
I Within sight of the garage door.
II Out of reach of children at minimum height of 5' (1.5 m).
III Away from all moving parts of the door.
8. Place entrapment warning label on wall next to garage door wall control.
9. Install the emergency release handle on the emergency release rope.
10. Place manual release/safety reverse test label in plain view on inside of garage door.
11. Upon completion of the installation, the door must reverse when it comes in contact with a 1 1/2"
(3.8 cm) high object on the floor (or a 2x4 laid flat at the centre of the door) and when the infrared
safety beam is blocked.
To Next Page
Loading...
Need help?
General
