model no. 046-0266-0 | contact us 1-800-689-9928
40
PROGRAMMING GUIDE – GARAGE DOOR OPENER
PROGRAMMING GUIDE – GARAGE DOOR OPENER
While programming, the p and q buttons can be used to move the door as needed.
A. Set Up Travel Limit and Open/Close Force
1. Connect the opener to an approved power
source. The dot in the LED display stays on.
2. Press and hold [SET] button for 5 seconds
until the LED display shows the numbe.
“1”. Release the [SET] button.
3. Press the p button until the door is in fully
open position.
4. Press the [SET] button to confirm the door
position.
SET DOOR TRAVEL
LIMIT (OPEN/CLOSE)
5. The LED display will show the number “2”.
6. Press the q button until the door is in fully
closed position.
7. Press the [SET] button again to confirm.
8. 8. The LED light will flash 3 times when the
travel limit settings are completed.
SET DOOR TRAVEL
LIMIT (CLOSE/OPEN)
9. The LED display will show the number “3”.
10. Press the wall button to open the garage
door to its fully open position.
11. The LED light will flash 3 times.
LEARN DOOR FORCE
(OPEN/CLOSE)
12. The LED display will show the number “4”.
13. Press the wall button again to close the
garage door to its fully closed position.
14. The LED display will turn off.
LEARN DOOR FORCE
(CLOSE/OPEN)
To Next Page
Loading...
Need help?
General
