model no. 046-0266-0 | contact us 1-800-689-9928
MAINTENANCE
Battery Replacement
All remotes come with battery installed. To replace the battery, follow the instructions below.
It is time to change the battery when the red LED light on the remote does not turn on when either
button is pressed.
Lithium battery CR-2032 included (positive side up).
To replace the battery:
1. Undo the two screws on the back of the remote. The bottom case will then come off.
2. Take out the old battery.
3. Place the new battery in position.
4. Close the cover and reinsert two screws.
WARNING
To prevent possible serious injury or death:
• Never allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
Battery Disposal:
• Please dispose the used battery per municipal or provincial law.
To Next Page
Loading...