PROGRAMMING GUIDE – WALL CONSOLE
While programming, the UP and DOWN buttons can be used to move the door as needed.
1. Connect the opener to an approved power
source. The dot in the LED display stays on.
2. Press and hold button on the wall
console for 5 seconds until the LCD display
shows the number “1” and up and down
arrows are flashing.
3. Press the Ç button until the door is in fully
open position.
4. Press the
button to confirm the door
position.
5. The LCD display will show the number “2”.
6. Press the È button until the door is in fully
closed position.
7. Press the
button again to confirm.
8. The LED light will flash 3 times when the
travel limit settings are completed.
9. The LCD display will flash the number “3”.
10. Press the
button to open the garage
door. The flashing “3” will change to solid.
11. The LED light will flash 3 times again when
the door is fully opened.
12. The LCD display will flash the number “4”.
13. Press the
button again to close the
garage door. The flashing “4” will change
to solid.
To Next Page
Loading...