Operating the Door
Activate your opener by:
• Pressing the wall console.
• Pressing the assigned button on the remote control.
Depending on the status of the garage door opener and the position
of the garage door, the garage door opener behaves in different
ways:
• If the door is closed, activating it will open the door.
• If the door is open, activating it will close the door.
• If the door is closing, activating it will stop the door.
• If the door is opening, activating it will stop the door.
If the door is obstructed:
• While opening, the door will stop.
• While closing, the door will reverse.
• The opener light will flash.
Opener Light
The opener light will turn on:
• When the opener is plugged in (light will turn off automatically after 3 minutes).
• When the opener is activated (light will turn off automatically after 3 minutes).
• When the light button is pressed on the wall console.
You can manually turn on the light with the wall console.
Remote Control
To activate the opener with the remote control, hold down the button until the door
begins to move. When the button is pressed, the light indicator on the remote will
flash. For remotes with multiple buttons, press the button programmed to the
desired operation.
WARNING
To prevent possible serious injury or death from a falling garage door:
• If possible, use emergency release handle to disengage trolley only when garage door is
closed. Weak or broken springs or unbalanced door could result in an open door falling
rapidly and/or unexpectedly.
• Never use emergency release handle unless garage doorway is clear of persons and
obstructions.
• Never use handle to pull door open or closed. If the rope knot becomes untied, you could
fall.
To Next Page
Loading...
Need help?
General
