model no. 046-0266-0 | contact us 1-800-689-9928
PROGRAMMING GUIDE – WALL CONSOLE
14. The garage door opener will beep once
when door is fully closed and the display
will show “F”.
15. Press the Ç or È button to set the force 0,
1, 2, or 3. 0 is the default force level. 3 is
maximum force level.
16. Press
button again to confirm the force
at the desired level.
17. The LCD display will flash the remote icon.
18. Program a Remote:
Within 30 seconds, press any button on the
remote that you would like to program to
the opener.
Program a Wireless Keypad:
Within 30 seconds, activate the keypad by
entering:
a. Pin code plus [#] for single door
. operation.
b. Pin code plus [#] plus [Door Number] for
. multiple door operation.
19. The garage door opener will beep if remote
is successfully programmed and the
flashing remote icon will change to solid.
20. If you want to erase all the remotes, press
and hold the È button for 5 secs until you
see “E."
21. If you need to program additional remote,
press Ç button, then refer to step 18. After
you’ve programmed all remotes, press
button.
To Next Page
Loading...
Need help?
General
