model no. 046-0266-0 | contact us 1-800-689-9928
INSTALL SAFETY BEAM SENSOR
Route and Secure the Sensor Wires
Run the wires up the wall, then over to the centre of the door. Secure the wires to the wall with wire
holders. Run the wires along the top of the T-rail and secure them with 4 wire clips provided.
Connect the Wires to the Opener
Twist like-coloured wires together. Connect the wires to the safety sensor terminals .
Wires are not polarity sensitivity (either wire to either terminal).
NOTE:
Remove the spring bracket from the mounting bracket if installing to the wall or floor.
1. Slide the sensor from the
mounting bracket.
2. Slide the spring bracket from
the mounting bracket.
3. Re-install and secure the sensor
to the mounting bracket.
To Next Page
Loading...