Mastervolt Masterlink BTM III User Manual

SETTINGS MENU
EN / Masterlink BTM-III / November 2006 27
10.17 RESET TO FACTORY SETTINGS
Here all settings will be reset to the original factory settings when Set is held for
three seconds.
10.18 SOFTWARE VERSION
This level shows the installed software version; this value cannot be changed
10.19 NMAE OUT: ON/OFF
See chapter 11.9.
Factory setting: OFF
10.20 EXIT LEVEL
From here you can return to the main menu (chapter 6) by pressing Set shortly.
Also, if none of the buttons was touched for 60 seconds, the Masterlink BTM-III
returns to the main menu.
RESET TO FACT.
PRESS SET 3S
Select
SOFTWARE VER.
0.00
Select
NMAE OUT.
OFF
Select
EXIT LEVEL
PRESS SET
Select
Back to lock mode

Mastervolt Masterlink BTM III Specifications

General

Brand	Mastervolt
Model	Masterlink BTM III
Category	Monitor
Language	English