EasyManua.ls Logo

Mastervolt MLI Ultra 12/2750

Mastervolt MLI Ultra 12/2750
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
MLI Ultra 12/2750, 12/5500, 24/5500 User and Installation Manual
Events
With MasterBus a device can be programmed to initiate an action at another connected device. This
is very helpful in automation of your system and is done by means of event-based commands.
In the Events tab you can program the MLI Ultra to act as an event source. Events which occur
during the operation of the MLI Ultra will then trigger actions from other products.
Field
Description
Value
Event x source
Select an event that triggers an action, for
example Relay open.
See Event source list
Event x target
Select the device that should act, for example the
charger.
Selectable targets are
system dependent
Event x command
Select the parameter that must be changed on
the target device, for example No connection.
See command list of
the selected device
Event x data
Data translates the input into an output.
On: status changes to On at first input signal.
Off: status changes to Off at first input signal.
Copy: status follows input signal.
Copy invert: status follows opposite of input.
Toggle: status changes at 1
st
signal and back
at the 2
nd
.
Off, On, Copy,
Copy Invert, Toggle
Input
On
Off
Copy
Copy invert
Toggle

Related product manuals