MTS600 Instruction Manual
75
④Press [ESC] to return.
10.3 Define function of the USER key
For convenience of user, there is a function key named [USER] on panel of
MTS-600, user can define the function that often used to the key. After power on,
pressing [USER] key directly can enter the function quickly.
The following functions can be defined to the [USER] key:
(1)Meas/Rec data: in basic measurement mode（angle, distance, coordinate
measurement）measure and recorde data.
(2)View JOB: review data stored in the current JOB.
(3)Send data: send JOB data in instrument ‘s memory to PC.
(4)Receive data: receive known coordinate data from PC.
(5)Input coord.: input and record known coordinate data.
(6)Input code: input and record codes.
(7)Resection: enter the program of resection measurement.
(8)Offset-meas: enter the program of offset measurement.
(9)MLM : enter the program of missing line measurement(MLM).
(10)REM: enter the program of remote elevation measurement(REM).
(11)Area calcul.: enter the program of area calculation.
(12)Instr. setting: set the parameters of instrument.
Operation of defining function is the same as described in "10.2 Operation of
setting parameters".
l Default function defined by factory is "Meas/Rec data".
l Please see details of these function in previous chapter.
Parama Setting <5/6>
F1-Temperature unit
F2-Pressure unit
F3-Auto power off
To Next Page
Loading...
